- 1). Remove your Acura Legend's negative battery cable with your wrench.
- 2). Pull the lid off your Acura Legend's relay panel and remove the relay you wish to test out. The relays themselves are marked, but there will also be a relay diagram printed on the inside of the relay panel lid.
- 3). Turn on the power to your voltmeter and also make sure the setting is switched over to ohms.
- 4). Place one of your voltmeter's test leads to one of your Acura's relay power terminals and the other meter lead to the other relay power terminal. A reading on the volt meter showing any continuity means the relay is bad. If no continuity is registered it means the relay is OK and the problem lies elsewhere.
previous post
next post