- 1). Sand down all four pallets to eliminate rough edges and corners.
- 2). Measure the distance across the face of a pallet.
- 3). Set two pallets on end with the bottoms facing each other. Space the pallets a distance equal to the measured width of the pallet face.
- 4). Set the third pallet on its side between the other two. Place this pallet so its sides butt against the bottoms of the other two pallets. Move the middle pallet to where the middle board of the side pallets are located. Drill screws through the sides of the middle pallet into the corresponding boards of the side pallets. Use four or more screws to ensure stability.
- 5). Turn the structure so the top of the middle pallet faces up. The middle pallet becomes the seat, with the two support pallets forming the arms and sides.
- 6). Position the fourth pallet halfway up the back edges of the side pallets with the pallet face forming the back of the chair. Drill screws through the underside of the top of the fourth pallet into the sides of the two side pallets and the seat. This forms the back of the chair.
- 7). Stain the chair if desired. Paint the chair with water-resistant stain.
previous post