- 1). Close your phone, turn it over and slide the back battery cover down and off the device. Then lift the rectangular battery out of its compartment.
- 2). Insert the tip of your small Phillips screwdriver in the seam between the plastic panel on the bottom of the device and the body of the phone. Gently pry up to pop the panel off the phone.
- 3). Use your screwdriver to remove the four screws on each corner of the back of the phone. Then remove the plastic panel from the back of the phone to expose the circuit board and internal components underneath.
- 4). Use your fingers to lift the circuit board from the housing of the phone and expose the back of the plastic keypad.
- 5). Use your fingers to lift the keypad out of the housing of the phone.
- 6). Turn your phone right-side up and use your fingers to gently pry the plastic panel off the front of the phone and expose two screws underneath.
- 7). Use your screwdriver to remove the two screws on the top of the phone, just above the front LCD screen.
- 8). Insert the tip of your screwdriver underneath the thin metal frame surrounding the LCD screen and gently pry up to remove it.
- 9). Lift the LCD screen out of the frame of your phone. At this point your Motorola V360 is completely open.
previous post
next post