- 1). Reinforce the stability of the fabric, if needed, by adding buckram to the back side.
- 2). Trace a design onto the fabric and insert the fabric in an embroidery frame or hoop. Stretch the fabric taut and tighten the frame.
- 3). Embroider the fabric in areas where beads will not be added. This is common with wedding dress designs where there is both embroidery and beading. Embroider the areas that will take beading but detail only the stitches that will remain visible.
- 4). Bead using two beading needles and beading thread. Knot the end of the thread. Pull the needle and thread from the back to the front of the fabric. Knot and thread the second needle and bring it up 1/32 of an inch along the beaded line. Pick up the beads you will use in your first line.
- 5). Lay the beads along the bead line. Cross your second needle over your beads, between bead 1 and 2, staying close to the bead line, and thread the needle to the back of the fabric and back up next to the gap between bead 2 and 3. Cross your needle over your beads, down and back up again. The second needle wraps around the beading thread between each bead. When done correctly there will appear to be no space between the beads in a line. As you go around curves, the space between beads will open a bit.
previous post