A new battery comes in a discharged condition and must be charged before use (refer to the devices manual for charging instructions). Upon initial use (or after a prolonged storage period) the battery may require three to four charge/discharge cycles before achieving maximum capacity.

When charging the Dell JKVC5 battery for the first time the device may indicate that charging is complete after just 10 or 15 minutes. This is a normal phenomenon with rechargeable batteries. Remove the battery from the device, reinsert it and repeat the charging procedure.

It is important to condition (fully discharge and then fully charge) the battery every two to three weeks. Failure to do so may significantly shorten the batterys life (this does not apply to Li-Ion batteries, which do not require conditioning). To discharge, simply run the device under the batterys power until it shuts down or until you get a low battery warning. Then recharge the battery as instructed in the users manual.

If the laptop battery will not be in use for a month or longer, it is recommended that it be removed from the device and stored in a cool, dry, clean place.

It is normal for a battery to become warm to the touch during charging and discharging.

A charged battery will eventually lose its charge if unused. It may therefore be necessary to recharge the battery after a storage period.

The milliamp-hour (mAH) rating of the Hi-Capacity battery will often be higher than the one on the original battery. A higher mAH rating is indicative of a longer lasting (higher capacity) battery and will not cause any incompatibilities. A Hi-Capacity battery will, in most cases, outperform the original by 30% to 50%.

Actual battery run-time depends upon the power demands made by the equipment. In the case of notebook computers, screen brightness, the use of the CPU, the hard drive, and other peripherals results in an additional drain upon the HP ProBook 4710s battery, effectively reducing the batterys run-time. The total run-time of the battery is also heavily dependent upon the design of the equipment. To ensure maximum performance of the battery, optimize the computers power management features. Refer to the computer manual for further instructions.