Rear Turn Signal Bulb Replacement

• 1). Open the seat and remove the two bolts that secure the tail light compartment panel to the frame. Pull the panel out from the compartment.
  
  
• 2). Remove the turn signal bulb socket from the rear of the turn signal assembly by twisting the socket counter-clockwise. Pull the old bulb straight out of the socket and press the new bulb gently into the socket until it is seated. Then, place the socket into the rear of the turn signal assembly and twist it clockwise to lock it into position.
  
  
• 3). Replace the access panel and screws, then lower the seat until it locks.
  
  

Front Turn Signal Bulb Replacement

• 1). Remove the screws that secure the front inner cover panel to the frame. There are a total of ten screws, four on each side and one at each upper corner.
  
  
• 2). Pull the cover panel away from the frame to access the front turn signal assemblies. The ignition switch may be attached to the cover panel, so be careful not to damage the ignition switch wiring during removal of the panel.
  
  
• 3). Remove the turn signal bulb socket from the rear of the turn signal assembly by twisting the socket counter-clockwise. Pull the old bulb straight out of the socket and press the new bulb gently into the socket until it is seated. Then, place the socket into the rear of the turn signal assembly and twist it clockwise to lock it into position.
  
  
• 4). Replace the front inner cover panel and screw in the ten mounting screws.